Navigaton
Sticker Size Key
When (T) is in the size selection this denotes height of the sticker if nothing after the size then this will be the width of the sticker.
All graphics come with full fitting instructions.
|
|
|
Dry Installation Method
Step 1
| Make sure the surface is clean of dirt, dust. Also, if you are applying the stickers/decals to a painted surface, please note that you must clean any wax off of your paint before applying the decals. Use rubbing alcohol (do not use household glass cleaners) to make sure all oily residues are removed. Allow the surface to dry. YOUR STICKER/DECAL WILL NOT STICK IF THE SURFACE IS DIRTY OR WET. |
Step 2
| Line up your sticker/decal where you want it and secure one edges with masking tape. This will help make sure the decal goes on straight. |
Step 3
| Carefully remove the protective wax-paper backing. If the stickers/decals look like they are sticking to the protective backing, gently help them along by lifting them with a knife or a pin. Be careful not to touch the sticky side of the decal with your fingers. The oil on your fingers may prevent the decals from sticking. |
Step 4
| Starting from the top slowly smooth the sticker/decal onto the application surface. Go over the sticker/decal a few times with a credit card or Tesco club card to make sure that all bubbles have gone. Work from the middle of the sticker/decal out towards the edges. |
Step 5
| Wait a couple of minutes when fully smoothed |
Step 6
| Slowly remove the transfer tape. The sticker/decal will be left behind on the application surface. |
You're done! Enjoy!
Wet Installation Method (suitable for windscreen stickers and large graphics)
Step 1
Make sure the surface is clean of dirt, dust. Also, if you are applying the sticker/decals to a painted surface, please note that you must clean any wax off of your paint before applying the decals. Use rubbing alcohol (do not use household glass cleaners) to make sure all oily residues are removed. Allow the surface to dry. YOUR STICKER/DECAL WILL NOT STICK IF THE SURFACE IS DIRTY.
Step 2
Line up your sticker/decal where you want it and mark the edges with masking tape. This will help make sure the decal goes on straight.
Step 3
Mix a small amount of washing up liquid with some water in a spray bottle. Spray the application surface and surrounding areas. Make sure it is very wet.
Step 4
For larger stickers/decals, you may need another person to help you. Carefully remove the protective wax-paper backing. If the decals look like they are sticking to the protective backing, gently help them along by lifting them with a knife or a pin. Be careful not to touch the sticky side of the decal with your fingers. The oil on your fingers may prevent the decals from sticking. Hold the decal over the application surface.
Step 5
Slowly lower the sticker/decal onto the application surface, making sure that it does not stick to itself. Since the surface is wet, you can slide the decal around until it is positioned exactly where you want it. Squeegee out the excess water and bubbles with a credit card or Tesco club card. Work from the middle of the sticker/decal out towards the edges. Leave the Sticker/decal and transfer paper until the surface and surrounding areas is dry. (depending on the temperature, this could take up to a couple of hours)
Step 6
Slowly remove the transfer tape. The sticker/decal will be left behind on the application surface.
Step 7
You're done! Enjoy!
|
|
